Make a cable tidy
I created this tutorial for the Buzz Feed website. I loved creating it as it was a bit of a challenge to do something I wouldn’t usually do and be given a little brief for a craft make – it got the cogs whirring!
You can see the tutorial on the Buzz Feed website, but all the instructions are below too!
You will need: two wooden clothes pegs, all purpose glue, washi tape in colours or patterns of your choice, and your headphones.
Get your pegs right: First you need to check the pegs are the right size for your headphones. Open one of the pegs and clamp around the wire just below the jack plug of your headphones. If the jack plug doesn’t fall through the end, you’re onto a winner. If it does, you’ll need to get some slightly smaller pegs.
Get taping: Bare wooden pegs are OK but you’ll want to add a bit of colour and fun to your cable tidy. To do this add some washi tape down one side of each of the pegs. Pick your favourite colours or patterns, I went for some black and white dots, but you could try neons, or pastels which would look great against the light wood.
Glue it together: Once you’re all washi taped up, use the all purpose glue to sandwich the non-decorated sides together. The pegs will need to top-and-tail each other as shown, so you can wind your headphones round it properly.
It’s a wrap: Woo hoo! You’re pretty much there, you just need to add your headphones – et voila! Start by putting the jack plug into the end of one of the pegs, then wrapping the cable round and round your new creation. Once you run out of cable, open the other peg and secure around the wire under the earbuds.
Ready to go: So there you have your super-simple cute cable tidy.
I made a few more and played with some colour combos, for one of them I also decided to offset my pegs slightly to add a little something extra to the design.